Skip to content

Re-Gain

This feature allows you to change the gain/trim of a channel without affecting the monitor sends / gate / dynamics.

A typical use case would be if an input is suddenly louder than anticipated, and you need to adjust the gain but keep the monitor sound stable.

Theory of operation

Gate and dynamics thresholds will be increased / decreased with the gain value. Sends / Faders will be adjusted in the inverted direction.

Re-Gain only works when the gain/trim gets changed form within the app. Any changes made on the mixer side are ignored by Re-Gain. This is to prevent a scene-recall from causing unexpected changes being made.

Re-Gain must be enabled after every reconnect to prevent unexpected changes due to the user forgetting about it being enabled.

Usage

There are two different modes of operation: Global or Temporary usage

Global usage

Re-Gain can be enabled globally and will be applied as soon as any gain/trim of an input channel gets changed inside the app.

  1. Press the ... menu button in the mixer view
  2. Select Gain Assist
  3. Adjust the scope settings to your liking
  4. Press Enable (You can also use an action to enable/disable Re-Gain)

It is possible to put a single channels into temporary usage mode again by following the steps below.

Temporary usage

This section describes how to use Re-Gain temporarily for a single channel.

  1. Open the config page of the relevant channel
  2. Press and hold the gain knob (or right-click)
  3. Enable "Re Gain" from the top menu
  4. Adjust the gain
  5. As soon as you close the popup Re-Gain will be disabled again

Re-Gain popup

The red lines in the gain slider indicate the minimum/maximum gain adjustment Re-Gain is able to compensate without altering the signal relations. If you exceed the lines some parameters (for example thresholds, send levels, ...) are at their limit, and any further gain adjustments will begin to alter the sound of your mix.

You can press the gear icon to change Re-Gain settings.

Scope

The scope defines which parameters are adjusted by Re-Gain.

Scopes

Scope Description
Sends Adjusts all pre-fader sends > -90dB
Gate Adjusts the gate threshold
Compressor Adjust the compressor threshold
LR Compensates the main fader
Other mains Compensates any additional mono/stereo main faders

Example

Value Before After
Gain 0dB 5 dB
Gate thr -20dB -15dB
Fader -15dB -20dB

Re-Gain example